Site managed, and products distributed in Australia, by MRT Performance

Increase Power and torque

Did you know that your car is detuned!
Unlock the hidden potential of factory ECU's

Learn more Power & Torque

Improve reliability, economy

100% money back satisfaction
Guarantee National Warranty

National Dealer Network

Worlds Number 1 here in Aus

Mitsubishi (UK with the FQ models)
Cosworth (USA and UK)
Subaru (UK with the Prodrive models)
Learn more Tuning Software

Mitsubishi EVO X supports the legendary Mitsubishi EVO X and Lancer Ralliart vehicles.

96 ECU versions are currently supported from all regions.

FlashCAN Mitsubishi EVO X Features

Mitsubishi EVO X allows you to alter parameters in the ECU, such as:

  • Fuel Tables
  • Ignition Timing Tables
  • Desired Boost Pressure & Wastegate Solenoid Control Maps
  • Boost Limit
  • Turbo Dynamics Control
  • Rev Limit
  • Speed Limit
  • Idle Speed Control
  • Fuel Injector Scaling
  • Fuel Injector Battery Voltage Compensation
  • Intercooler Spray Control (not available on all models)

Mitsubishi EVO X

RaceROM EVO X

RaceROM supports all models of the Mitsubishi EVO X.

RaceROM EVO X supports the following feature enhancements:

DTC Enable & Disable

Diagnostic trouble codes can now be enabled and disabled in the ECU, allowing you to tune further without the ECU going into special conditions.

Custom Live Data Support

Mitsubishi EVO X RaceROM enables FlashCAN EVO to measure and log extra diagnostic parameters not accessable as standard, such as:

  • Engine Load
  • Charge Air Temperature
  • Boost

 

Supported Vehicles

ProECU Mitsubishi EVO X currently supports over 70 different ECU versions.

Mitsubishi EVO X and Lancer Ralliart Vehicles:

  • AUS Mitsubishi EVO EVO 10 SST 2011
  • AUS Mitsubishi EVO Lancer Ralliart SST 2011
  • EU Mitsubishi EVO 10 5 Speed 2008
  • EU Mitsubishi EVO 10 5 Speed 2011
  • EU Mitsubishi EVO 10 SST 2008
  • EU Mitsubishi EVO Lancer Ralliart 2009
  • JDM Mitsubishi EVO 10 5 Speed 2008
  • JDM Mitsubishi EVO 10 5 Speed GSR 2009
  • JDM Mitsubishi EVO 10 5 Speed GST 2009
  • JDM Mitsubishi EVO 10 5 Speed GST 2010
  • JDM Mitsubishi EVO 10 5 Speed RS 2008
  • JDM Mitsubishi EVO 10 5 Speed RS 2009
  • JDM Mitsubishi EVO 10 5 Speed RS 2010
  • JDM Mitsubishi EVO 10 SST 2008
  • JDM Mitsubishi EVO 10 SST 2009
  • JDM Mitsubishi EVO 10 SST 2010
  • JDM Galant Fortis 2009
  • SA Mitsubishi EVO 10 SST 2010
  • UK Mitsubishi EVO 10 5 Speed 2008
  • UK Mitsubishi EVO 10 SST 2008
  • US Mitsubishi EVO 10 5 Speed 2008
  • US Mitsubishi EVO 10 5 Speed GSR 2010
  • US Mitsubishi EVO 10 5 Speed GSR 2011
  • US Mitsubishi EVO 10 SST 2008
  • US Mitsubishi EVO 10 SST 2009
  • US Mitsubishi EVO Lancer Ralliart 2009

Live Data

When connected to a car, ProECU Mitsubishi EVO X can offer real time data and map tracing.

The below example data for 27 out of approximately 70 live data parameters is available from the "Live Data" tab of the ROM file being accessed. This data is accessed directly from the ECU in real time.

  • RPM: Engine speed. (Revolutions Per Minute)
  • Injector Duty Cycle: Percentage of time that the injector is open vs. closed (the time available changes as Engine speed increases (becomes less).
  • Fuel Trim Short Term & Long Term: This is the percentage of fuel trim that the ECU adds or subtracts to obtain stoichiometric AFR. This is useful to determine when the ECU is running in open/closed loop mode
  • Ignition Timing: This displays the actual ignition timing that the ECU is currently using
  • Knock Retard: Knock retard is the amount of Ignition timing removed by the ECU because of knock
  • Air Flow: Shows the reading from the Mass Airflow sensor
  • External Lambda/AFR Input Channel: This will only be displayed if an External Sensor has been configured in DeltaDash.
  • Custom RaceROM parameters such as:-
    • Engine Load
    • Charge Air Temperature
    • Boost

 

It is possible to log the data shown during Map Access mode for analysis in DeltaDash or ProECU.
It is then possible to customise the way the logged data are displayed using the Time Graphs, Data Table, Custom 2D Graphing, and Custom 3D Graphing tabs in the Log Viewer, as shown below:


Mitsubishi EVO X

Mitsubishi EVO X

Live Map Access

The example below shows how the Live Coloured Map Tracing feature shows the Knock correction on the Ignition Map.
It is possible to get more detailed information by holding the mouse over a specific value.

Mitsubishi EVO X

Performance Books